Universal machining center

DMG MORI DMU 60 evo

We offer you the following:

Technical Data:

Control: Heidenhain iTNC 530 HSCI

Dwsdexgnz Tepfx Ab Uod
Travel distances:
- X-axis: 600 mm
- Y-axis: 500 mm
- Z-axis: 500 mm

Main spindle:
- Speed range: 20 - 18,000 rpm

NC Rotary Table:
- Clamping surface: 600 x 500 mm
- Load capacity: 400 kg
- B-axis: -5° to +110°
- C-axis: 360°

Tool changer:
- Tool holder: HSK-A63
- Number of tool pockets: 210 positions

Equipment and Accessories:
- Heat exchanger for spindle and table
- Active cooler for control cabinet
- Direct measuring system
- Full enclosure
- 3D control
- DMG ERGOline Control
- Direct measuring systems in the NC rotary/swivel table incl. table cooling
- BLUM NT laser tool measurement
- Calibration arbor with tool holder
- Infrared probe, Heidenhain TS 649
- Preparation for 3D quickSET
- Hinged belt chip conveyor
- ICS, 40 bar, 600 l tank, incl. rotating viewing window, sealing air, linear measurement systems, bed flushing
- Rinsing pistol
- Mechanical oil and emulsion mist separator
- Air blast through spindle center
- Mode of operation 4
- Machine preparation for handling systems, consisting of:
- Automatic, lateral loading door
- Electrical interface for articulated arm robot
- Pneumatic control and monitoring of the zero-point clamping system
- Activation/deactivation of handling system via switch on machine operator panel
- Additional rinsing in the machining area included
- Preparation for job management included
- Operator panel arrangement on the left included
- Power supply to machine table incl. 2-channel rotary union
- Additional machine-side clamping hydraulics, 1 clamping circuit:
- Clamping hydraulics, 1 circuit, 30 - 240 bar, pressure adjustment via proportional valve technology
- Extension of rotary union to 4 channels included

On-time hours: approx. 66,600 h
Spindle hours: approx. 44,800 h

The robot shown in the pictures is not included in the scope of delivery.
The machine is expected to be available from October/November 2025.
The ball screw drives and linear guides in the X and Z axes have been replaced.

Accessories, depicted tools, and clamping equipment are only included if specifically mentioned in the additional information.
Subject to changes and errors in the technical specifications and information. Prior sale reserved!

آگهی به صورت خودکار ترجمه شده است. احتمال بروز اشتباه در ترجمه وجود دارد.