DMG DECKEL MAHO DMC 64V linear

DMG DECKEL MAHO DMC 64V linear

This 4-axis DMG DECKEL MAHO DMC 64V linear was manufactured in 2002. It features a travel of 640 mm on the X-axis, 600 mm on the Y-axis, and 500 mm on the Z-axis. The machine has a maximum spindle speed of 12,000 rpm and a tool magazine capacity of 30. If you are looking to get high-quality machining capabilities, consider the DMG DECKEL MAHO DMC 64V linear vertical machining centre we have for sale. Contact us for further details.

• Condition: Used (good)
• Operating hours: 24396 h
• Electrical:
• Nominal power: 39 kVA
• Voltage: 400 V
• Frequency: 50 Hz
• Secondary voltage: 230 V
• Control voltage: 24 V
• Current: 63 A
• Current (max): 56 A
• Rapid traverse:
• X: 60 m/min
• Y: 40 m/min
• Z: 40 m/min
• Feed Force (X, Y, Z-Axis - 40% ED): 7000 N
• Feed Speed (X, Y, Z-Axis): max. 40 m/min
• Rapid Traverse (Y, Z-Axis): 40 m/min
• Rapid Traverse (X-Axis): 60 m/min
• Ball Screw Diameter/Pitch (X, Y-Axis): 40 x 15 mm
• Position Accuracy (Y, Z-Axis Standard - Indirect Measurement System): 0.020 mm
• Position Accuracy (X-Axis Standard - Direct Measurement System): 0.005 mm
• Position Accuracy (Y, Z-Axis Option - Direct Measurement System): 0.008 mm
• Resolution: 0.001 mm
• Input Resolution (X, Y, Z-Axis): 0.001 mm
• Main Drive Power (40% / 100% ED): 18 / 14 kW
• Main Drive Torque (40% / 100% ED): 95 / 75 Nm
• Front and Rear Spindle Bearing Diameter: No specification
• Spindle Speed: Infinitely programmable from 0 to 12,000 min⁻¹
• Setup Operation Spindle Speed: 0 to 800 min⁻¹
• Program Check with Manual Intervention Spindle Speed: 0 to 5,000 min⁻¹
• Motor Type: Direct drive via speed-controlled asynchronous motor with liquid cooling
• Maximum Torque (S1 - 100% ED): 70 Nm
• Maximum Torque (S6 - 40% ED): 100 Nm
Hnodpfx Aaeyz Tkfezjp
• Maximum Motor Power (S1 - 100% ED): 13 kW
• Maximum Motor Power (S6 - 40% ED): 19 kW
• Included Equipment: Chip Conveyor (Spiral type)
• Chip Conveyor Discharge Height: 380 mm
• On this machine, compressed air can be activated through the spindle using an M-code command