Wood shredder

die magnetprofis Winkelförderband Z-Förderband

Aluminum Z-conveyor belt with base frame, including adjustable feet and freely swiveling transport castors with parking brakes.

Horizontal section: 800 mm
Inclined section: 3,000 mm
Second inclined section: 1,200 mm
Angle of incline at each bend: 60°
Total conveyor belt length measured on the floor: 3,500 mm
Njdpfxjyhzhnj Abmeda

Height of the horizontal section: 400 mm
Design:
- Aluminum construction with 2x reinforced profile, 90x45 mm
- Full-surface discharge sheet, 2.0 mm, galvanized
- Drive roller and deflection roller made from welded and machined S235 steel
- Ø100x720 mm crowned turning, shaft fixed with pillow block bearings
Drive: Parallel shaft geared motor 1.10 kW, belt speed: 0.53 m/sec
Connection: 230/400V, 50 Hz, protection class IP54
Drive wired ready for connection up to the motor junction box (commissioning must be performed by a qualified electrician)

PU conveyor belt DM 10/2 0+005 PU, including wave edge PU, petrol matt finish, AS, especially cross-rigid with hard cover
Conveyor belt width: 700 mm
2 pcs. wave edges, 50 mm high, 25 mm wide, high-frequency welded
34 pcs. T40 cleats, centered, 430 mm long, spacing approx. 299 mm
Belt material: 2-ply, especially cross-stable
At each bend, the belt is guided on both sides with 3 hold-down rollers each.

The belt is manufactured with a 70 mm edge-free zone on each side.
Due to the wave edge on both sides, the usable belt width is reduced:
Usable width: 500 mm, determined as follows:
(top view) Cross-section 70+25+5+500+5+25+70 mm

Belt guidance via PVC V-guide on the running surface, profile 10x6 mm
- Includes cut-out in the discharge sheet
- Includes slide bushings in the drive and deflection rollers

آگهی به صورت خودکار ترجمه شده است. احتمال بروز اشتباه در ترجمه وجود دارد.