Crane hall

DEMAG Kranhalle 492m² + 288m²

CRANE HALL with ADDITION 492 m² + 288 m² with 2 x 10-ton crane runways *for DIY enthusiasts*
DEMAG, year of construction 1988
Crane hall (all dimensions are approximate)
Width: 13.50 m
Length: 36.50 m
Eaves height: 8.89 m
Ridge height: 9.25 m
Roof slope: 3.05°
Snow load at previous location: approx. 85 kg/m²
Crane runways: 2 pieces
Crane runway 1: 10 tons
Cantilever at a height of: 8.85 m, the same for both cranes
Hook height at 7.00 m, the same for both cranes
Serial No. 1: Serial No. 88205500 Type FKKF, year of construction 1988
Drive motor 1
Hjdpfx Aoz Hlx Honfou
Crane runway 2: 10 tons
Serial No. 2: Serial No. 88205510 Type FKKF, year of construction 1988
Drive motor 2

Addition
Width: approx. 12.00 m
Length: approx. 24.00 m
Height: approx. 5.60 - 6.00 m
Crane runway support provided for approx. 2.5 - 4 tons

Equipment
Supports: HEA 400, 14 pieces, 9.80 m, 17,150 kg
incl. struts to truss, approx. 1.40 m
Truss: IPE 400, 7 pieces, 10.70 m, 4,966 kg
Gable wall supports
Wall posts: IPE 140, 32 pieces, 6.00 m, 2,478 kg
Pressure tubes roof: DN 80, 14 pieces, 6.00 m, 528 kg
Gable wall supports
Wind bracing in 3rd bay, 10 mm, 10 pieces, 6.23 m, approx. 23 kg
Crane runway rails: 2 x 36 m

1 gable frame
Supports: IPE 360, 3-4 pieces
Pressure tubes: 90 mm, 11 pieces
Corner supports: HEA 300, 3 pieces, 5.60 m

The supports were cut off, 1 support was tapered, approx. 60 were embedded in concrete.

Roofing: none
Wall panels: none
Windows: none
Doors: none
Gates: none
Power cable crane runway: none
Structural calculations / plans: none
Lighting: none
Crane runway drive, addition: none

آگهی به صورت خودکار ترجمه شده است. احتمال بروز اشتباه در ترجمه وجود دارد.