Packaging machine

Becker BZ-2 Atomic

Becker BZ-2 Atomic – Packaging System

- 2 identical, mirror-inverted packaging lines available
- Without cutting machine
- Year of manufacture: 2020

In this system, the cardboard is first trimmed at the front to remove any potential transportation damage. After edge trimming, a side trim of at least 30 mm is performed on both sides. If necessary, corners are also cut from the cardboard, depending on the FEFCO type. Finally, the cardboard is creased along the fold lines and conveyed out of the machine.

Waste generated during the process is transported out of the machine via a waste conveyor belt located underneath. At the machine’s discharge end, a conveyor belt removes the waste into a container. If the edge trim is too long, it must be cut inside the system to ensure trouble-free removal from the machine.

Rjdpfx Aboygipmjvsn
The cut blanks and products are conveyed to the folding table where cartons are erected and filled. In the Box Closing Unit, the cartons are closed, labeled, and discharged from the system.

Machine components (see diagram):

(1) Buffer Table | (2) Conveyor Pack System | (3) Folding Table FT30 | (4) Box Closing Unit | (5) Label Applicator | (6) Belt Conveyor | (7) Buffer Table | (8) Conveyor Pack System | (9) Folding Table FT30 | (10) Box Closing Unit | (11) Label Applicator | (12) Belt Conveyor

Technical Data:

- Sound pressure level: < 70 dB(A)
- Operating voltage: 400 V / 50 Hz
- Rated current: 47 A
- Main fuse: 63 A
- Connected load: 32.5 kW
- Control voltage: 24 V
- Compressed air supply: 6 bar
- Air consumption: 10 l/min
- Machine dimensions (W x H x D): 21,260 x 4,000 x 18,030 mm

آگهی به صورت خودکار ترجمه شده است. احتمال بروز اشتباه در ترجمه وجود دارد.