XTS 35 for powder coatings

Xtrutech XTS 35

Xtrutech XTS 35 for powder coatings (180-350 kg/hr)

1. PURPOSE AND MAIN FUNCTIONS OF THE LINE

The extrusion line for powder coating production is part of a whole production process and is used for the production of polymer powder coatings. The extrusion line includes the following technological processes: formation of a homogeneous melt of heated powder coating by mixing, shaping of the melt, subsequent cooling of the product and its crushing into fine fractions.

2. LINE COMPONENTS

- Twin-screw extruder type XTS

3. DESCRIPTION OF THE EXTRUDER COMPONENTS

3.1. Twin-screw extruder type XTS 35

The extruder for powder coating production consists of:
- 24D hydraulically opening barrels at the top and bottom, providing quick access for cleaning, maintenance and emergency repair of barrel liners and screw element shafts.
- Rectangular loading port for dosing of materials which are difficult to dose.
- Robust high flow water cooled units with 5 electrically heated (aluminium bronze heating plates of 2 kW each) control zones that provide excellent temperature control. Maximum operating temperature is 350°C.
- The barrel on the discharge side is equipped with a cooled discharge adapter and a knife.
- Screws with screw elements. Screw speed 0 - 900 rpm. Water cooled AC motor power of 26kW. The stepless (PIV) gearbox is rated at 139Nm and protected by an automatic torque limiter.
- Latch lock / quick-release coupling of shaft connection and toothed shaft.
Mains supply voltage: 400±6%, 3 phases, 50 Hz (o+earth). Control: 24V.
Water-supply: 70 l/min at 15°C and a coolant pressure of 4bar.
Approximate dimensions: L=2250mm W=1000mm H=1600mm
Approximate weight: 1600kg.

Lhedpfx Aowz Ntioi Tjf
High-volume geometry D/d =1.8
AC motor power 26 kW
Screw speed 900 rpm
Average output 180 - 220 kg/h, max. 350 kg/h