Horizontal machining center SH50

MORI SEIKI SH-50

We are offering this used MORI SEIKI SH-50 horizontal machining center, year of manufacture 1996.

Model: SH-50
Serial number: 450

Pedpfx Adsyt Nnpsrjpr
The machine is still under power and available at short notice.

• P8 Power Supply worth €1,500 was newly replaced in August 2024
• The spindle was repaired in 2017 and, since then, has mostly been used in single-shift operation, as we primarily produce single parts and small batches. For this reason, the machine has spent most of its time being set up.

• Machine: Milling machine Mori Seiki SH50
• Control: Fanuc MSX-516
• Year of manufacture: 1996
• Configuration: Horizontal milling machine with indexing table
• Tool capacity: 60 (BT40)
• Number of pallets: 2 (500mm x 500mm)
• Travels: X630mm / Y600mm / Z650mm
• Spindle speed: 12,000 rpm
• Chip conveyor

Known defects:
Rapid traverse speed of the X axis has been reduced by 20% to extend the life of the telescopic covers.
The sealing ring on the pallet changer is likely defective, leading to oil leakage. As a temporary fix, we installed a ball valve in between; when we need to change pallets (which is not very often), we open it manually.

The machine is sold as viewed, without any guarantee or warranty. Any liability for defects, including hidden defects, is excluded to the extent permitted by law.

If you have any questions or need further information, please feel free to write us a message or call us.

آگهی به صورت خودکار ترجمه شده است. احتمال بروز اشتباه در ترجمه وجود دارد.