Lowbed

Fliegl DTS 300 P

Further information
Chassis, low-bed trailer
Steel welded construction
Turntable with robust ball bearing race, storage box integrated into the turntable extension
Foldable rear support
2 chock blocks with holder
Aluminum side impact protection
Splash guard at the rear over the entire width
Extendable widening elements to 3,000 mm (not in the rear slope)
(However, the track width of the construction machinery or vehicles to be transported must not exceed the outer frame width of 2,550 mm)
Storage compartment for wooden planks in the center of the loading area
Wooden planks 70 mm for widening to 3,000 mm
Tie-down points, low-bed trailer
3 pairs of tie-down points, each rated at 10 tons, integrated in the floor at the front
6 pairs of tie-down eyes embedded in the top and side of the outer frame, each rated at 10 tons
1 at the neck area
the rest distributed in between, with a maximum distance of 1200 mm
1 at the rear slope
5 pairs of pocket housings embedded in the outer frame, 70 x 40 mm inside (can be converted to 5-ton ring tie-down points, not included)
Coupling device, trailer turntable
Drawbar with tested 40 mm drawbar eye
Axles + Suspension
SAF drum brake axles
Axle/suspension laser-aligned, reducing tire wear and fuel consumption
Parabolic suspension with maintenance-free steel-rubber bearing and mechanical
axle load compensation (rocker compensation)
Braking system
2-line compressed air braking system
Color-coded line routing for easy servicing.
Spring-loaded parking brake, including
2 fail-safe coupling heads at the front, with connecting lines to the towing vehicle,
ABS and ALB, with ABS connector at the front, with connecting cable,
Note: The attached trailer may only be towed by towing vehicles that guarantee the effectiveness of the ABS!
Wheels and tires
235 / 75 R 17.5
according to the manufacturer's choice
Steel rims in twin arrangement, factory silver
Electrical system
24 Volt, multi-chamber lights, yellow LED lighting on the sides
2 white position lights at the front
2 white/red outline lights at the rear
2 x 7-pole fail-safe connectors at the front, with connecting cable,
1 LED rotating beacon with holder, switched via parking lights (beacon can be removed)
2 pairs of warning signs, double LED illuminated and extendable to 3,000 mm
Floor
Front area, steel floor,
followed by 70 mm soft wood floor, in the wheel arch area, steel/diamond plate covering
Rear slope with 70 mm soft wood floor
Low-bed platform including rear slope 8,200 mm
Ramps
Steel ramps 2,800 mm long, 750 mm wide, laterally movable
covered with wood, including
with spring-assisted support
Operating instructions
At an axle load of 10,000 kg, a special permit is required; only indivisible loads are possible!!!
The specified total weight is technically possible; depending on the load, the total weight may not be reached while adhering to the permissible axle/support and saddle loads (poor driving and following behavior possible due to incorrect load distribution).
Lasdpfx Agji Riy Eodec
Country of registration/plates
Country of registration: Germany
with Dekra approval and certificate (according to §13 EG - FGV)
24/7 service hotline
prepared for two-line license plate holder
Contour marking with reflective tape according to ECE R 048, white on the sides and red at the rear
Paint finish
Frame DB 7350 Novagrau
10-year warranty against rust
Drawbar, galvanized or black
according to the manufacturer's choice
Ramps, hot-dip galvanized
Note: Archive images!

آگهی به صورت خودکار ترجمه شده است. احتمال بروز اشتباه در ترجمه وجود دارد.