Cantilever rack

Fischer

FISCHER – Cantilever racking for installation in enclosed spaces.
The racking must not be clad on-site without consulting FISCHER.
Design according to the specifications.
Racking No. 1 - single-sided (cantilever arms bolted on).
Number of racks: The following information refers to 1 rack.
1 unit
Number of uprights: 3 units
Racking length (center-to-center distance): 2,500 mm
Distance between uprights: 2 x 1,250 mm
Upright height (hole pitch 100 mm): approx. 2,500 mm
Top storage level: 2,200 mm
Foot length: 1st side/2nd side 2,000 / 0 mm
Cantilever arm lengths (total length incl. end stop): 2,000 mm
Cantilever arms: 1st side/2nd side 4 / 0 units
Desired load capacity per cantilever arm: 500 kg
Load capacity per upright side (without considering the foot): 2,000 kg
Max. floor pressure: 0.11 kN/cm2
Shipping weight per rack: 607 kg
Color of uprights: fire red, similar to RAL 3000
Color of cantilever arms: fire red, similar to RAL 3000
1 spray can
The profile thickness applies to 100% utilization of the rack load capacity.
Seismic zone could not be determined.
A verifiable or tested static analysis is available for an additional charge.
Text for the static calculation:
Important note regarding the static calculation of the storage system: The static calculations take into account the fundamentals according to Eurocode (DIN EN 1991-1-1, DIN EN 1991-3 and DIN EN 1991-1-4) and the framework conditions of the respective national annexes (NA) applicable in the countries where the system will be installed. Since storage systems are usually installed in urban or industrial areas, the requirements applicable to these areas (e.g., for Germany, ground category III and IV) are included in the calculation.

Important note regarding building permits, please note:
Storage systems may require a permit according to the respective state building code. In the event of an order placed with Fischer, the client undertakes to obtain the necessary public-law permits for the storage system. If the permit is not granted, or the granted permit is revoked or withdrawn, the contractor shall not be liable for this. In the event of installation by Fischer, we generally assume that a valid building permit is in place at the time of installation. Any necessary verifiable static calculations for the building application can be obtained for a fee; please contact us.

Pedpfx Ajzab Rcjd Rept
Cantilever racking: 1 unit 1,500.00
Foot rounding as a safety element: 3 units 13.50 per foot and side
Storage location: Customer

آگهی به صورت خودکار ترجمه شده است. احتمال بروز اشتباه در ترجمه وجود دارد.