Gear Honing Machine

FÄSSLER D - 250 / H5

workpiece diameter 250 mm
centre distance 0 mm
honing length max. mm
max. module 5
Gear Ø, min./max. 10 / 250 mm
Module range 1 - 5
Length of teeth / max. table stroke 500 mm
Height of centres of tailstocks 220 mm

Max. weight of workpiece 50 / 100 kg
Honing head swivelling +/- 35 °

Speeds of honing tool 20 - 500 rpm
Size of honing tool, Ø x width 300 x 40 mm

Workpiece speeds 500 - 3,000 rpm
Total adjustment of cross slide 270 mm
Rapid traverse of cross slide 50 mm
Infeed travel of cross slide, mechanical 1 - 8 mm/Ø
Roughing / finishing infeed 1 - 29 / 0.2 - 2.8 mm/sec

Table speeds, hydraulic 0 - 6 m/min

Total electrical load 5.5 kW - 380 V - 50 Hz
Weight 3,200 kg

Accessories / Special Features
* Working parameters can be preset using counters and control units. Automatic working process with workpiece counter.
* All roughing and finishing infeeds can be adjusted by a decade switch; as well as by table reverse times and fast infeeds with preset times (1sec = Ø 0.04 mm), set on a potentiometer. Ampere display, etc.
* Convex honing and conical honing are possible via templates. Asymmetric honing is also possible if the workpiece is prepared appropriately (i.e. pre-shaped).
* Separate honing oil unit with magnetic separator and fine filter.
Gjdpfxot Hwzpj Abksiu
* Mechanical tailstocks for manual loading. * Oil mist separator.
* Sliding doors with foot switch. * Separate hydraulic unit.


Condition : Good. Machine can be inspected under power.
Delivery : Ex stock, as inspected.
Payment : Net, after conclusion of contract.

We have a large selection of gear machines available. Please let us know your requirements.